Electronic PSU / Control overhaul kit for Revox C270, C274 and C278

$445.00 AUD

Includes power supply and full tape transport electronic systems

For all Revox C270, C274/8.

This kit contains parts for the very important power supply, tape control, logic, and transport functions modules.

Replacement capacitors for all the electrolytics including large PSU can type caps which are specifically made for the C27 series with 4 pins that fit correctly in place. Very important for the C27 series as its a complex board. with through hole vias around the special 4 pin capacitors.
Replacement for all tantalum capacitors
Brand new specially manufactured non polarised motor capacitors
Replacement of all troublesome suppression capacitors on drive control, switching and mains suppression
Fully enclosed cermet type preset potentiometers to replace old open type trimmers
Most axial capacitors are replaced with appropriately rated brand new manufactured axial capacitors.
63V rated electrolytics replaced with correct 63V or higher voltage types (the C27 series has quite a few of these oddball voltage caps)

This kit considers / caters for the following circuit boards.

Main Control
Special 4 pin PSU capacitors - NEWLY manufactured n 2017 not NOS that have been sitting for 10 years or more!
Distributor
Capstan Servo
Tacho
Connection
All motor chassis mounted motor capacitors
A basic set of Nagravox service sheets / manual is provided to assist you with your overhaul that compliments the factory manual.

TOTALS: Capacitors =70 - 95. Trimmers = 9 - 11.

PLEASE NOTE: Standard kit is for standard C270, 274/8. If you have a special version please email me to discuss.

AUDIO kit. For a full kit - please see other listings. For C274 and C278 - inquire and we can put together an audio kit for you.

Nagravox